Determining the Formula of an Unknown Hydrate Essay Example for Free

Determining the Formula of an Unknown Hydrate actThe final equations that was concluded after the experiment and the calculations areCuSO4 5H2O and MgSO4 5H2O. There are 5 body of water molecules per bruiser (II) Sulphate and 7 water molecules per Magnesium Sulphate. The compounds are all hydrates which is a subject matter that contains water. This occurs when crystals form from the dehydration of an aqueous solution of a table flavour and water molecules become included into the crystal. The hydrates were heated and lost its water of hydration and made it possible to calculate how much water was in the hydrate and the water to salt ratio. The dowery error for the Copper (II) Sulfate was 4.61%. It is a large error but the coefficient was correctly rounded to the accept value of 5. The percentage error for Epsom salts was 5.51% which is also very large but can also be rounded to the accepted value of 7.Errors and LimitationsErrorExplanationSuggested ImprovementsNo lidW ithout a lid on the evaporating dish, the powder popped out the dish when heated therefore causing the mass of the stay substance to be lowerUsing a lidImprecise measurements of massCausing the mass of the evaporating dish, H2O and the remaining hydrate to be lowered or raised and therefore makes the final formula incorrect devising sure the surface of the scale is clean and waiting until the weight displayed has completely stoppedNo profoundness in experimentMore experiments can be done for comparison and further our knowledge of hydrates other Sulfate hydrate to compare the hydrates and see if there is a pattern of the different hydrate and the spell of water molecules due to factors of periodicity. Also we could have also just used sulfate hydrate to restrain how adding another element affect the water and salt ratio.Overheating of the substancesThe hydrates were heated under the Bunsen burner and were left over(p) under the heat for too long. This could alter the result by l owering the mass, which would increase the water to salt ratio.Mixing the powder to evenly distribute the heat to prevent overheating the salt.Not letting the substance cool before measure itThis would raise the mass of the anhydrate because the water molecules would not be entirely evaporated reservation the substance left heavier.Having more patience and letting the salt completely cool before weighingOval chunks of CuSO4 remain after burningNot all of the water of hydration has been removed which will piss off the result by decreasing the mole of water and the increase the final water to salt ratio.Break up the chunks before heating or while heating.